![background image](http://html1.mh-extra.com/html/martin/dt2h/dt2h_installation-manual_1732845024.webp)
© Martin Engineering GmbH
14
M3699UK-11/13
Installation
1. Connect the compressed air line with the interfaces that are lo-
cated at the bottom of the installation console at the back side
of the chute.
2. First route the compressed air line through the shaft and then
through the holder on the operator side. Ensure that the line is
guided under the grip. Connect the compressed air line with an
interface of the T-piece of the compressed air bellows on the
operator side. If needed, shorten the compressed air line to the
required length.
3. Connect the other interface of the T-piece with the input of the
compressed air system or, if required, with the output of the
pressure control device. Connect the compressed air supply or
a compressed air system to the input of the pressure control de-
vice.
Summary of Contents for DT2H
