![background image](http://html1.mh-extra.com/html/martin/dt2h/dt2h_installation-manual_1732845022.webp)
© Martin Engineering GmbH
12
M3699UK-11/13
Installation
4.2.4
Centre the scraper shaft below the conveyor belt
Measure the distances (A) and (B) between the edge of the cleaner
blades and the conveyor belt edge on both sides.
Slide the scraper shaft until distance A is equal to distance B. The
conveyor belt should protrude about 50 to 100 mm on both the left
and the right sides. The cleaner blades must be positioned in the
middle under the conveyor belt.
CAUTION! DANGER OF DAMAGE!
Damage to the conveyor belt edge and / or the
cleaner blades is possible by misalignment of the conveyor belt.
Alignment of the main scraper in accordance with the following
instructions.
NOTE
The following drawings are illustrative and may vary from the main
scraper actually used.
Abb. 8: Centring the conveyor belt scraper shaft (example)
A = B
A
B
Summary of Contents for DT2H
