Manitou MT 625 H 75K COMFORT ST5 S1, Operator'S Manual

Page: 37 / 136

1 - 33
BRINGING THE LIFT TRUCK BACK INTO SERVICE
-Remove the waterproof adhesive tape from all the holes.
-Refit and reconnect the battery.
-Remove the protection from the cylinder rods.
-Perform the daily maintenance operations (
e
3 - MAINTENANCE).
-Put the handbrake on and remove the axle stands.
-Drain and clean the fuel tank (
e
3 - MAINTENANCE).
-Fill the fuel tank with clean diesel filtered through the filler port.
-Replace the fuel filter (
e
3 - MAINTENANCE).
-Replace the fuel pre-filter (
e
3 - MAINTENANCE) (depending on the model of lift truck) .
-Drain and rinse the DEF tank (depending on the model of lift truck) .
-Top up, slowly fill the tank with new “DEF” (Diesel Exhaust Fluid) up to the bottom of the filler neck (depending on the model
of lift truck) .
-Refit the drive belts and adjust the tension (
e
3 - MAINTENANCE).
-Turn the engine over with the starter, to allow the oil pressure to rise.
-Reconnect the engine cut-off solenoid.
-Lubricate the lift truck completely (
e
3 - MAINTENANCE).
t
IMPORTANT
t
Ensure the area is sufficiently ventilated before starting the lift truck.
-Start up the lift truck, following the safety instructions and regulations (
e
OPERATING INSTRUCTIONS UNLADEN AND
LADEN).
-Carry out all the boom hydraulic movements, concentrating on the ends of travel for each cylinder.
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1