Manitou MT 625 H 75K COMFORT ST5 S1, Operator'S Manual

Page: 106 / 136

3 - 20
1
5
6
3
4
2
܌
500H - PERIODIC SERVICE - EVERY 500 HOURS OF SERVICE OR 1 YEAR
CHECK Hydraulic oil
MANITOU offers a hydraulic oil analysis kit which might make it possible to delay the
recommended deadline in the periodic maintenance schedule (2000 hours). In this
case we recommend an analysis of the hydraulic oil every 500 hours or 1 year of service.
The oil analysis kit also makes it possible to confirm the oil quality so as to obtain a
deadline of 2000 hours for specific uses causing constraints on the hydraulic circuit:
extreme environmental conditions, use of the attachments with a very high hydraulic
flow rate (such as a sweeper, or a concrete mixer).
-Order an oil analysis kit from your dealer.
-Upon receiving the kit, take a sample of oil and follow the instructions shown on
the kit.
-According to the results, keep the analysis report or replace the hydraulic oil.
MANITOU oil analysis kit Part No. 958162.
REPLACE Engine oil
REPLACE Engine oil filter
Place the lift truck on level ground, let the engine run at idling speed for a few minutes,
then stop the engine.
t
IMPORTANT
t
Dispose of the drain oil in an ecological manner.
Tighten the oil filter by hand pressure only and lock the filter in place by a quarter turn.
DRAINING THE OIL
-Open the engine cover.
-Remove access panel 1.
NOTE: When removing cover plates and hatches, clean the surrounding area and
remove any accumulations of flammable materials.
-Place a container under the drain hole and unscrew the drain plug 2.
-Remove the filler plug 3 to ensure correct drainage.
REPLACEMENT OF THE FILTER
-Unscrew and discard the engine oil filter 4, together with its seal.
-Clean the filter bracket with a clean, lint-free cloth.
-Lightly oil the seal before refitting the new oil filter (
e
FILTER ELEMENTS AND
BELTS) on its bracket (tightening torque 11 - 12,5 ft-lbs 15 - 17 N.m).
FILLING WITH OIL
-Refit and tighten the drain plug 2.
-Fill up with oil (
e
LUBRICANTS AND FUEL) through filler hole 5.
-Wait a few minutes to allow the oil to flow into the sump.
-Start the engine and let it run for a few minutes.
-Check for possible leaks from the drain plug and the oil filter.
-Stop the engine, wait a few minutes and check the correct level between the two
marks on the dipstick 6.
-Top up the level if necessary.
-Refit the access cover 1.
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1