Manitou MT 625 H 75K COMFORT ST5 S1, Operator'S Manual

Page: 131 / 136

2 - HYDRAULIC ATTACHMENT AND MANUAL LOCKING DEVICE
FITTING AN ATTACHMENT
-Ensure that the attachment is in a position facilitating the locking to the carriage. If
it is not correctly oriented, take the necessary precautions in order to move it safely.
-Check that the locking pin is in position in the bracket (Fig. A).
-Place the lift truck with the boom lowered in front of and parallel to the attachment,
and tilt the carriage forwards (Fig. B).
-Bring the carriage under the locking tube of the attachment, slightly raise the boom,
tilt the carriage backwards in order to position the attachment (Fig. C).
-Lift the attachment off the ground to facilitate locking.
MANUAL LOCKING AND CONNECTION OF THE ATTACHMENT
q
IMPORTANT
q
Make sure that the rapid connectors are clean and protect the holes which are not used, with the caps provided.
-Take the locking pin on the bracket and lock the attachment (fig. D). Do not forget
to fit the cotter pin.
-Stop the engine and keep the ignition on the lift truck.
-Release the pressure in the attachment hydraulic circuit by operating switch 1 on
the distributor lever backwards and forwards 4 or 5 times.
-Connect the quick-release couplers according to the logic of the attachment’s
hydraulic movements.
MANUAL RELEASE AND DISCONNECTION OF THE ATTACHMENT
-Proceed in the reverse order of paragraph MANUAL LOCKING AND CONNECTION
OF THE ATTACHMENT, taking care to refit the locking pin in the bracket.
REMOVING THE ATTACHMENT
-Proceed in the reverse order to FITTING AN ATTACHMENT, taking care to store the
attachment flat on the ground and in the closed position.
4 - 5
A
B
C
D
E
1
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1