Manitou MT 625 H 75K COMFORT ST5 S1, Operator'S Manual

Page: 100 / 136

3 - 14
1
1
2
2
1
1
CHECK Alternator/crankshaft belt tension
t
IMPORTANT
t
If the belt is changed, check the tension again after the first 20 hours of service.
-Open the engine cover.
-Check the belt for signs of wear and cracks, and change if necessary (
e
FILTER
ELEMENTS AND BELTS).
-Check the belt tension between the fan pulley and the alternator
pulley (22,03 lbs / 98 N). The clearance should be about 0,3 to 0,4 in (7 to 9 mm).
-Adjust if necessary.
-Loosen screws 1 by two to three thread turns.
-Swivel the alternator assembly so as to obtain the required belt tension.
-Retighten screws 1 (tightening torque 16 ft-lbs ±1,6 ft-lbs 22 N.m ±2,2 N.m).
CHECK Tyre pressures
CHECK Wheel nut tightening
t
IMPORTANT
t
Check that the air hose is correctly connected to the tyre valve before inflating and keep all persons at a distance during inflation. Follow the recommended tyre pressures.
-Check the condition of the tyres, to detect cuts, blisters, wear, etc.
- Check the wheel nut tightening. Non-compliance with this instruction can lead to deterioration and breakage of the
wheel bolts and distortion of the wheels.
-Check and restore tyre pressures if necessary (
e
2 - DESCRIPTION: TYRES).
NOTE: There is an OPTIONAL wheel tool kit.
CHECK Transfer box oil level
Place the lift truck on level ground with the engine stopped.
-Visually check for any traces of seepage or leakage from the various filler, level
and drain plugs.
-If there is any leakage or seepage, check the level.
-Remove the level plug 1, the oil should be flush with the edge of the hole.
-If necessary, add oil (
e
LUBRICANTS AND FUEL) by the same hole.
-Refit and tighten the level plug 1 (tightening torque 25 - 36 ft-lbs 34 - 49 N.m).
Ü
50H - WEEKLY SERVICE OR EVERY 50 HOURS OF SERVICE
CHECK Compressor belt tension (Air conditioning option)
t
IMPORTANT
t
If the belt is changed, check the tension again after the first 20 hours of service.
-Open the engine cover.
-Check the belt for signs of wear and cracks, and change if necessary (
e
FILTER
ELEMENTS AND BELTS).
-Check the belt tension between the pulleys of the crankshaft and the compressor
-Under a normal pressure exerted with the thumb (10 lbs / 45 N), the clearance
should be approximately 0,39 in (10 mm).
-Adjust if necessary.
-Loosen the screws 1 and nuts 2 by two to three thread turns.
-Swivel the compressor assembly so as to obtain the belt tension required.
-Re-tighten screws 1 and nuts 2 (tightening torque 16 ft-lbs ±1,6 ft-lbs 22 N.m
±2,2 N.m).
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1