Manitou MT 625 H 75K COMFORT ST5 S1, Operator'S Manual

Page: 36 / 136

1 - 32
IF THE LIFT TRUCK IS NOT TO BE USED FOR A LONG TIME
INTRODUCTION
The following recommendations are intended to prevent the lift truck from being damaged when it is withdrawn from service
for an extended period.
t
IMPORTANT
t
Procedures to follow if the lift truck is not to be used for a long time and for starting it up again afterwards must be performed by your dealership.
This period of long-term stoppage must not exceed 12 months.
After 12 months, repeat the procedures for putting the lift truck back into service and long-term stoppage.
PREPARING THE LIFT TRUCK
-Clean the lift truck thoroughly.
-Check and repair any fuel, oil, water or air leaks.
-Replace or repair any worn or damaged parts.
-Wash the painted surfaces of the lift truck in clear and cold water and wipe them.
-Touch up the paintwork if necessary.
-Stop the lift truck (
e
OPERATING INSTRUCTIONS UNLADEN AND LADEN).
-Make sure the boom cylinder rods are all in the retracted position.
-Release the pressure in the hydraulic circuits.
DEF (Diesel Exhaust Fluid) TANK
Depending on the model of lift truck
-Drain and rinse the DEF tank.
-Replace the “DEF” (Diesel Exhaust Fluid) supply pump filter (
e
3 - MAINTENANCE).
-Slowly fill the tank with new “DEF” (Diesel Exhaust Fluid) up to the bottom of the filler neck.
-Start up the lift truck to pressurise the circuit and bring it up to working temperature, then shut down the engine.
-If necessary, top up the tank.
PROTECTING THE ENGINE
-Contact your dealer to obtain the procedure for protecting the inside of the engine (use of protection product).
-Fill the tank with fuel (
e
3 - MAINTENANCE).
-Drain and replace the coolant (
e
3 - MAINTENANCE).
-Leave the engine running at idling speed for a few minutes, then switch off.
-Replace the engine oil and oil filter (
e
3 - MAINTENANCE).
-Run the engine for a short time so that the oil and cooling liquid circulate inside.
-Disconnect the battery and store it in a safe place away from the cold, after charging it to a maximum.
-Block the outlet with waterproof adhesive tape.
-Remove the drive belts and store them in a safe place.
-Disconnect the engine cut-off solenoid on the injection pump and carefully insulate the connection.
PROTECTING THE LIFT TRUCK
-Set the lift truck on axle stands so that the tyres are off the ground.
-Release the parking brake (depending on the model of lift truck) .
-Protect cylinder rods which will not be retracted, from corrosion.
-Wrap the tyres.
NOTE: If the lift truck is to be stored outdoors, cover it with a waterproof tarpaulin.
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1