Manitou MT 625 H 75K COMFORT ST5 S1, Operator'S Manual

Page: 108 / 136

3 - 22
2
1
1
2
3
4
3
4
REPLACE Hydraulic return oil filter cartridge
Stop the engine and release the pressure from the systems by operating the hydraulic
controls.
t
IMPORTANT
t
Raise the boom and place the boom safety wedge on the rod of the lifting cylinder (
e
1 - INSTRUCTIONS AND SAFETY
RECOMMENDATIONS: LIFT TRUCK MAINTENANCE INSTRUCTIONS).
Thoroughly clean the outside of the filter and its surroundings before any operation to prevent any risk of polluting
the hydraulic system.
-Remove cap 1.
-Place a container under hydraulic return oil filter.
-Unscrew the cover 2.
-Wait a few seconds for the oil to flow into the container.
-Slowly take out filter cartridge assembly 3 and 4.
-Separate the head 3 from the filter cartridge 4 with a twisting motion.
-Refit the head onto a new cartridge (
e
FILTER ELEMENTS AND BELTS).
-Fit the assembly in place and re-tighten cover 2.
-Put the cap 1 back.
REPLACE Front axle differential oil
Place the lift truck on level ground with the engine stopped and the still warm differential
oil.
t
IMPORTANT
t
Dispose of the drain oil in an ecological manner.
-Place a container under drain plug 1 and unscrew the plug.
-Remove level and filling plug 2 to ensure correct drainage.
-Refit and tighten the drain plug 1 (tightening torque 25 - 36 ft-lbs 34 - 49 N.m).
-Fill up with oil (
e
LUBRICANTS AND FUEL) through filler hole 2.
-The level is correct when the oil level is flush with the edge of the hole.
-Check for any possible leaks at the drain plug.
-Refit and tighten the level and filling plug 2 (tightening torque 25 - 36 ft-lbs 34 - 49 N.m).
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1