Manitou MT 625 H 75K COMFORT ST5 S1, Operator'S Manual

Page: 107 / 136

3 - 21
1
1
3
2
4
1
3
2
REPLACE Fuel filter
t
IMPORTANT
t
Carefully clean the outside of the filter and around it, to prevent dust from getting into the system.
Tighten the filter by hand only and lock it by a quarter turn.
-Switch off the lift truck's ignition with the ignition key.
-Unscrew the filter 1.
-Clean the inside of the filter head using a brush immersed in clean diesel oil.
-Refit a new filter lubricated with clean diesel beforehand (
e
FILTER ELEMENTS
AND BELTS).
REPLACE Fuel pre-filter
t
IMPORTANT
t
Carefully clean the outside of the filter and around it, to prevent dust from getting into the system.
Tighten the filter by hand only and lock it by a quarter turn.
-Disconnect the wiring harness 1.
-Place a receptacle under the filter 2.
-Unscrew the filter 2.
-Clean the inside of the filter head using a brush immersed in clean diesel oil.
-Refit a new filter lubricated with clean diesel beforehand (
e
FILTER ELEMENTS
AND BELTS).
-Reconnect the wiring harness 1.
-Open bleed screws 3 and 4.
-Turn on the lift truck's ignition with the ignition key.
-Close the bleed screws 3 and 4 as soon as the diesel flows free of air.
REPLACE Transfer box oil
Place the lift truck on level ground with the engine stopped and the
transfer box oil still warm.
t
IMPORTANT
t
Dispose of the drain oil in an ecological manner.
-Remove access panel 1.
-Place a container under drain plug 2 and unscrew the plug.
-Remove level and filling plug 3 to ensure correct drainage.
-Refit and tighten the drain plug 2 (tightening torque 25 - 36 ft-
lbs 34 - 49 N.m).
-Fill up with oil (
e
LUBRICANTS AND FUEL) through filler hole 3.
-The level is correct when the oil level is flush with the edge of the hole.
-Check for any possible leaks at the drain plug.
-Refit and tighten the level and filling plug 3 (tightening torque 25 - 36 ft-lbs 34 - 49 N.m).
-Refit the access cover 1.
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1