Manitou MT 625 H 75K COMFORT ST5 S1, Operator'S Manual

Page: 102 / 136

3 - 16
1
2
3
3
2
1
1
2
CHECK Windscreen washer liquid level
-Open the protective casing 1 with the ignition key.
-Visually check the level in tank 2.
-If necessary add windscreen washer fluid (
e
LUBRICANTS AND FUEL).
-Remove cap 3.
-Add windscreen washer liquid through filler port.
-Refit the cap.
CLEAN Fuel pre-filter
t
IMPORTANT
t
Carefully clean the outside of the pre-filter and its holder, to prevent dust from getting into the system.
-Open the engine cover.
-Disconnect electrical wiring harness 1 from the fuel pre-filter.
-Place a receptacle under the drain plug 2 and unscrew it by two thread turns.
-Allow the diesel fuel to flow out until it is free from impurities and water.
-Re-tighten drain plug 2 and reconnect the wiring harness 1.
CHECK Hydraulic oil level
Place the lift truck on level ground with the engine stopped, and the boom retracted
and lowered as far as possible.
t
IMPORTANT
t
Use a clean funnel and clean the underside of the oil drum before filling.
-Check dipstick 1, the correct level must be at the level of the red dot.
-If necessary, add oil (
e
LUBRICANTS AND FUEL).
-Remove cap 2.
-Add oil through filler port 3.
-Refit the cap.
-Visually check that there is no leakage in the tank and pipes.
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1