Manitou MT 625 H 75K COMFORT ST5 S1, Operator'S Manual

Page: 101 / 136

3 - 15
1
2
3
1
1
CHECK Front axle differential seal
CHECK Rear axle differential seal
Place the lift truck on level ground with the engine stopped.
-Visually check for any traces of seepage or leakage from the various filler, level
and drain plugs.
-If there is any leakage or seepage, check the level.
-Remove the level plug 1, the oil should be flush with the edge of the hole.
-If necessary, add oil (
e
LUBRICANTS AND FUEL) through the filler hole 2.
-Refit and tighten the level plug 1 (tightening torque 25 - 36 ft-lbs 34 - 49 N.m).
CHECK Front wheel reducer seals
CHECK Rear wheel reducer seals
Place the lift truck on level ground with the engine stopped.
-Visually check for any traces of seepage or leakage from the level plug.
-If there is any leakage or seepage, check the level.
-Place level plug 1 in a horizontal position.
-Remove the level plug; the oil should be flush with the edge of the opening.
-If necessary, add oil (
e
LUBRICANTS AND FUEL) by the same hole.
-Refit and tighten the level plug (tightening torque 25 - 36 ft-lbs 34 - 49 N.m).
CHECK Brake fluid level
Place the lift truck on level ground.
t
IMPORTANT
t
If the brake oil level is abnormal consult your dealer.
-Open the protective casing 1 with the ignition key.
-Check tank 2. The correct level should be at the MAX. level on the tank.
-If necessary, add oil (
e
LUBRICANTS AND FUEL).
-Remove cap 3.
-Add oil through filler port.
-Refit the cap.
-Visually check that there is no leakage in the tank and pipes.
CHECK Boom pad slide pathways
To preserve optimum operation, the pad slide pathways should be correctly lubricated:
t
IMPORTANT
t
MANDATORY GREASING OF THE BOOM AFTER:
Cleaning the boom, especially after using high pressure cleaner.
The forklift has been unused for a long period of time.
-Fully extend the boom.
-Check the condition of the surface of the pad slide pathways, surface run in (steel
whitened) without traces of corrosion.
-If necessary lubricate the pad slide pathways (
e
LUBRICANTS AND FUEL).
-Telescope the boom several times in order to spread the lubricant evenly.
-Remove the surplus lubricant.
t
IMPORTANT
t
If the lift truck is used in an abrasive environment (dust, sand, coal.) use lubricating varnish (MANITOU reference: 483536). Please consult your dealer.
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1