Manitou MT 625 H 75K COMFORT ST5 S1, Operator'S Manual

Page: 111 / 136

3 - 25
1
2
3
4
5
1
1
1
1
2
3
3
REPLACE Alternator belt
t
IMPORTANT
t
Check the belt tension again after the first 20 hours of service.
REMOVING THE BELT
-Undo screws 1 and remove radiator protection grill 2.
-Loosen screws 3 by two to three thread turns.
- Swivel the alternator assembly so as to free belt 4.
- Pass belt 4 behind radiator propeller 5 to remove it and replace with a new one
(
e
FILTER ELEMENTS AND BELTS).
NOTE: Take advantage of belt removal to check the correct operation of the pulleys
and bearings (noise, rubbing, play, etc.).
REFITTING THE BELT
-Refit a new alternator belt (
e
FILTER ELEMENTS AND BELTS). Ensure that it is properly seated in the grooves of each pulley.
-Adjust the belt tension between the crankshaft pulley and the alternator pulley (22,03 lbs / 98 N). The clearance should
be about 0,3 to 0,4 in (7 to 9 mm).
- Swivel the alternator assembly so as to obtain the required belt tension.
-Retighten screws 1 (tightening torque 16 ft-lbs ±1,6 ft-lbs 22 N.m ±2,2 N.m).
-Refit the radiator protection grill 2.
REPLACE Engine crankcase ventilation filter
-Open the engine cover.
-Carefully clean the outside of the filter and its holder, to prevent dust from getting
into the system.
-Disconnect the hose 1 at the filter.
-Unscrew the cover 2.
-Take out the filter 3 and discard it together with the seal of the cover 2.
-Refit a new seal on the cover and insert a new filter (
e
FILTER ELEMENTS AND BELTS).
-Put back the cover 2 and tighten by hand only and lock by a quarter turn.
-Reconnect hose 1.
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1