Manitou MT 625 H 75K COMFORT ST5 S1, Operator'S Manual

Page: 121 / 136

3 - 35
REPLACE Wheels
For this operation, we advise you to use the MANITOU hydraulic jack Part No. 505507
and the MANITOU safety support prop Part No. 554772.
t
IMPORTANT
t
In the event of a wheel being changed on the public highway, secure the lift truck vicinity:
-Stop the lift truck, if possible on firm, level ground.
-Stop the lift truck (
e
1 - OPERATING AND SAFETY INSTRUCTIONS: DRIVING
INSTRUCTIONS UNLADEN AND LADEN).
-Switch on the hazard warning lights.
-Immobilise the lift truck in both directions on the axle opposite to the wheel to
be changed.
-Unlock the nuts of the wheel to be changed.
-Place the jack under the flared axle tube, as near as possible to the wheel and
adjust the jack.
-Raise the wheel until it is clear of the ground and place the safety support under
the axle.
-Completely unscrew the wheel nuts and remove them.
-Free the wheel by reciprocating movements and roll it to the side.
-Slip the new wheel on the wheel hub.
-Hand-tighten the nuts, grease them if necessary.
-Remove the safety support and lower the lift truck with the jack.
-Tighten the wheel nuts with a torque wrench (
e
2000H - PERIODIC
SERVICE - EVERY 2000 HOURS OF SERVICE OR EVERY 4 YEARS) for the tightening
torque.
647732
(31/10/2019)
MT
625
H
75K
ST5
S1
/ MT
625
H
75K
COMFORT
ST5
S1