Mallinckrodt INOMAX DSir Plus, Operation Manual

Page: 192 / 206

Part No. 20717 Rev-01
2014-07
8-10
Guidance and Manufacturer’s Declaration – Electromagnetic Immunity
The INOmax DS
IR
system is intended for use in the electromagnetic environment specified below. The
user of the INOmax DS
IR
system should assure that it is used in such an environment.
Immunity Test IEC 60601 test level Compliance Level
Electromagnetic
Environment Guidance
Electrostatic discharge
(ESD)
IEC 61000-4-2
± 6 kV contact
± 8 kV air ± 6 kV Contact
± 8 kV Air Floors should be wood,
concrete or ceramic tile.
If floors are covered with
synthetic material, the
relative humidity should
be at least 30 %.
Electrical fast transient/
burst
IEC 61000-4-4
± 2 kV for power supply
lines
± 1 kV for input/output
lines
± 2 kV for power
supply lines
±1 kV for input/output
Lines Mains power quality
should be that of a
typical commercial or
hospital environment.
Surge
IEC 61000-4-5 ± 1 kV line(s) to
line(s)
±2 kV line(s) to earth ± 1 kV differential
mode
±2 kV common mode Mains power quality
should be that of a
typical commercial and/
or hospital environment.
Voltage dips, short
interruptions and
voltage variations
on power supply
input lines
IEC 61000-4-11 <5 % U
T
(>95 % dip in U
T
)
for 0,5 cycle
40 % U
T
(60 % dip in U
T
)
for 5 cycles
70 % U
T
(30 % dip in U
T
)
for 25 cycles
<5 % U
T
(>95 % dip in U
T
)
for 5 s
< 5% U
T
(> 95% dip in U
T
)
for 0.5 cycle
40% U
T
(60% dip in U
T
)
for 5 cycles
70% U
T
(30% dip in U
T
)
for 25 cycles
< 5% U
T
(> 95% dip in U
T
)
for 5 sec.
Mains power quality
should be that of a
typical commercial and/
or hospital environment.
If the user of the system
requires continued
operation during power
mains interruptions, it is
recommended that the
system be powered from
an uninterruptible power
supply or a battery.
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
3 A/m 30 A/m Power frequency
magnetic fields
should be at levels
characteristic of a typical
location in a typical
commercial or hospital
environment
NOTE U
T
is the AC mains voltage prior to application of the test level.