Mallinckrodt INOMAX DSir Plus, Operation Manual

Page: 188 / 206

Part No. 20717 Rev-01
2014-07
8-6
Electrical
Input Voltage: 100-240 V AC @ 50 / 60 Hz
Input Power: 110 VA max
Input Fuse: 3 A
Classification: Class I, Type B
Standards: CSA certified to meet the following for medical electrical equipment:
• UL 60601-1: 2003 edition 2
• ANSI/AAMI 60601-1: 2005 edition 3
• IEC 60601-1: 2005 edition 3
Battery Backup: A sealed lithium ion rechargeable battery provides power backup
to operate the system for up to six hours when fully charged.
Connect the system to an electrical outlet for at least ten
hours to charge the battery.
When the low battery alarm occurs, there are 30 minutes
until battery depletion.
Dispose of used batteries according to local regulations.
USB Port: Not used. Not for use when patient is connected.
Ethernet Port: For service only. Not for use when patient is connected.
RS232: Enables serial communications for use with hospital electronic health record
(EHR) system (see specifications on page 8-7 ).
Infrared Port: Infrared communication with the INOMAX cylinder.
Important: Disconnect main power cord to isolate equipment from main power.
Environmental
Operating: Transport/Storage:
Temperature: 5 to 40°C -20 to + 60°C
Humidity:
15 to 95% RH
non-condensing
15 to 95% RH
non-condensing
Ambient
Pressure:
57 to 110 kPa 57 to 110 kPa
Water Ingress
Protection:
IPX1
INOMAX Regulator
Inlet Pressure: 14 to 155 Bar (200 to 2,248 psig)
Outlet Pressure: 1.7 to 2.4 Bar (25 to 35 psig)
Cylinder Valve Connector: CGA 626
Alarm Log
The alarm history is deleted when device is turned off. However, the service log, which is
accessible by service personnel is maintained (including alarm log) when power is cycled
and/ or when total power loss occurs.