Mallinckrodt INOMAX DSir Plus, Operation Manual

Page: 167 / 206

Part No. 20717 Rev-01
2014-07
7-1
Frequency Maintenance
Daily 1. Check the INOMAX cylinder pressure. A cylinder with less than 200 psig should
be replaced.
2. Empty the water trap bottle as needed.
Start of each
patient
Must perform the Pre-Use Procedure.
Between each
patient
1. Sterilize and/or disinfect the Injector Module.
2. Clean water trap bottle.
3. Replace the single patient-use items.
4. Make sure that the delivery system power cord is always plugged into an
emergency-power-backed electrical outlet.
5. Make sure the connectors, hoses and cables are in good condition.
Monthly 1. Perform a low and a high calibration of NO, NO
2
and O
2
.
2. Check INOMAX regulators for leaks.
7/ Maintenance
User Maintenance Schedule
Caution:
• To help prevent fire, use only lubricants approved for O
2
equipment, such as KRYTOX
®
.
• Do not use lubricants which contain oil or grease, as they burn or explode in high O
2
concentrations.
• Do not sterilize or disinfect with the power connected.
Note: The INOmax DS
IR
does not contain any user repairable parts.
Note:
A flashing date above the high sensor calibration button signifies a high
calibration is past due.