Mallinckrodt INOMAX DSir Plus, Operation Manual

Page: 117 / 206

Part No. 20717 Rev-01
2014-07
4-9
10 L/min
1. Use the Pre-Use set-up to connect to
sample gas from the INOblender.
Connect O
2
tubing to the front of the
INOblender.
2.Confirm the injector module is removed
from the Pre-Use set-up and connect the
adapters.
3. On the INOblender, set the INOMAX dose
to 40 ppm and O
2
flow to 10 L/min.
4. Verify NO value on the INOmax DS
IR
.
5. Turn the dose and oxygen flow to zero.
6. Remove the Pre-Use set-up from the
INOblender.
Acceptable
NO Value
32-48 ppm
4
1
2
3
5
5
2
3
40 ppm
4
Note:
• Confirm INOblender inlet hose is
connected to the INOMAX regulator
hose and the Quick-Connect cover
is in place.
• Confirm 50 psig oxygen supply
hose is connected to O
2
inlet fitting
on back of INOblender.