Diagnostic Manual MAN-00183
MAXXIMO
MINIVAN
VX June 2012
/
Rev
1
The reproduction, translation, transmission, in part of
or
whole of the present document are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any
person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution.
© 2012 Mahindra &
Mahindra Ltd.
30
DTC Detecting Condition
Probable Causes
An excessively low voltage ( 0 Volts) from the APP2 sensor
is sent to ECU.
An excessively high voltage(1.65 V for C04 ECU and 2.5 V for
C55 ECU ) from the APP2 sensor is sent to ECU.
APP1 and APP2 signals are not synchronized
Harness or Connectors
(The sensor circuit is open or
shorted)
Failed accelerator pedal
position sensor 2
Lamp Status
Check engine lamp ON
Fault Reaction
If malfunction is within APP2 and its circuit, then engine runs with throttle till 40% with quantity limitations
If both APP1 and APP2 malfunction, then engine will run at limp home mode i.e. the rpm will remain continuously
in 1200 rpm
CIRCUIT
Summary of Contents for Maxximo Mini Van Vx 2012
Page 274: ......
