Lucent Technologies LambdaUnite, Installation Manual, Page: 341 / 628

Connecting the WaveStar
®
CIT to the NE
.................................................................................................................................................................................................................................
Overview
The WaveStar
®
CIT can be connected to a network element in four different ways:
•
Direct LAN access (point-to-point)
NOTE: This is the only method of connecting before system parameters have been
set and before the network has been established.
•
LAN access (network)
•
Remote access via DCC
•
Remote access via TCP/IP.
Direct LAN access (point-to-point)
The WaveStar
®
CIT (LAN card) is connected to the LambdaUnite
®
MSS via the
“CIT” port of the user panel or through a backplane connector (LAN I/O Panel). A
shielded CAT5 crossover LAN cable with RJ-45/RJ-45 connectors (see chapter 4,
Figure 4-48, “CIT connection (LAN crossed)” (p. 4-74) ) must be used for this
connection.
NOTE: The crossing can also be realized by a C5XOVER adapter (female to female,
CC408357903). This adapter works inline with two CAT5 straight cables.
The following figure illustrates direct LAN access (point-to-point).
Safety
CAUTION
ESD hazard
Electronic components can be destroyed by electrostatic discharge.
Use a static ground wrist strap. Always observe the ESD instructions (cf. “Electrostatic
discharge” (p. 1-20) ).
Figure 7-1 Direct LAN access (point-to-point)
User Panel
NE ACTY
FE ACTY
ACO
LED TEST
CR
MJ
MN
ABN
PWR ON
CIT (LAN)
WaveStar CIT
®
NE provisioning
.................................................................................................................................................................................................................................
365-374-187
Issue 1, December 2005 Lucent Technologies - Proprietary
See notice on first page
7-3