Result:
The voltage on the PDP must be in the range of –40.5
{
–72.0 V DC.
CAUTION
: Do not proceed if the voltage is outside the range!
.................................................................................................................................................................................................
3
Switch the PI-A circuit breaker to the
ON
position (=“I”) using a small Phillips
screwdriver.
IMPORTANT:
The circuit breaker latch must be activated slowly. Otherwise it could
snap back to the
OFF
position.
Figure 5-1 PI/100 switching
PI-B
PI-A
Power, software and circuit pack installation
Switching on and testing the supply voltage
.................................................................................................................................................................................................................................
365-374-187
Issue 1, December 2005
Lucent Technologies - Proprietary
See notice on first page
5-5