Loma IQ3+, User Manual

Page: 190 / 251

Operating Instructions
180
4. In this screen you can now set the new users User ID, access level and password. Once you
have added all of the details, tap on the green tick 'OK' button to save the changes.
5.
Tap on the Back button .. The Save Settings pop-up screen will be displayed.
6. Tap on the green tick 'OK' button to save the changes and finish adding the new user
account.
Configuring the Metal Detector
Wherever possible, configuration of the metal detector will be carried out by Loma Systems before the
machine is dispatched, or by a Loma Service Engineer during a commissioning visit. Primarily, the
commissioning visit is required as part of the installation process so that the engineer can optimise
machine performance in its actual working environment and for the products that are to be inspected.
There are circumstances, however, where it may be necessary for the end user to carry out some or
all of the configuration and commissioning procedures. Typically, this would occur when Loma
Systems do not have enough information about the end application, such as the belt speed or reject
details, to fully configure the machine.
Options and parameters available for configuring the metal detector are listed and described below.
■
Setting Up the Search Head
■
Setting Up the Conveyor
■
Setting Up the Service Options
■
Setting Up the Monitoring Services
■
Setting the VF Balance
■
Setting the VF Drive
■
Setting Up the User Options
■
Setting Up Serial Links
■
Performing a Ferrite Tune
■
Setting Up Product Signal Tracking
■
Setting Up the Reject Options