Liquid Controls LectroCount LCR 600, Installation-Parts

Page: 71 / 78

Installation
71
Epson Printer Power
Power must also be supplied to the Epson printer. For supplying power to the printer, a 15-foot cable with
a 12/24VDC converter (825001) is also available. The red wire of this cable must be spliced into the red
wire in the gray power cable on the LCR 600 side of the 5 Amp fuse.
To connect power to the LCR 600 and the Epson printer:
1. Route the gray power cable to the accessory panel. See Routing LCD 600 Data and Power
Cables .
2. Splice the red wire from the printer power cable into the red wire of the gray power cable.
3. Splice the 7.5 Amp fuse into the red wire. Make the splice close to the direct power terminal
connection in the accessory panel, and on the power side of the splice made with the printer
power cable.
4. Connect the red wire to the direct power supply terminal in the accessory panel.
5. Connect the black wire of the gray power cable to a reliable DC ground.
6. Connect the black wire of the printer power to a reliable DC ground.
7. Tape the green drain wire of the gray power cable back against the power cable.
Power Check
After the LCR 600 has been installed, check to ensure that it powers up correctly. The LCR 600 display
and the printer power light should come on when the truck ignition is turned either to the
ON position or
the ACC position. Ensure that the printer power switch is on. If the LCR 600 or the printer does not power
up, check the wiring and the connections on the LCR 600 CPU board against the instructions in this
manual.
37