59
WWW.LCMETER.COM
LCI40
Series IOM
6 oPeration
No.
Function
Settings / Descriptions
C3._ Limit Switch X
C3._
Limit Switch X
X stands for one of the connection terminals A, B, C or D_ stands for Fct. C3.2 (A) / C3.3 (B)
/ C3.4 (C) / C3.5 (D)
C3._.1
Measurement
Select:
Volume Flow / Mass Flow / Temperature / Density / Velocity / Sensor
Average / Sensor Deviation / Drive Level / Tube Frequency / Strain 1 /
Strain 2 / 2 Phase Signal
C3._.2
Threshold
Switching level, set threshold with hysteresis
xxx.x ±x.xxx (format and unit depend on the measurement, see above)
(1st value = threshold / 2nd value = hysteresis), condition: 2nd value
≤
1st value
C3._.3
Polarity
Set polarity; the flow direction in C1.3.2 must be noted!
Select:both polarities (plus and minus values are displayed) /
Positive Polarity (display for negative values = 0) /
Negative Polarity (display for positive values = 0) /
Absolute Value (always displays positive, with both negative and positive values)
C3._.4
Time Constant
Range: 000.1 - 100 s
C3._.5
Invert Signal
Select:
Off (activated output: switch closed) /
On (activated output: switch open)
C3._.6
Information
Serial no. of the I/O board, software version no. and production date of the circuit board
C3._.7
Simulation
Sequence see B1._ Limit Switch X
C3._ Control Input X
C3._
Control Input X
C3._.1
Mode
X stands for connection terminal A or B_ stands for Fct. C3.2 (A) / C3.3 (B)
Off (control input switched off) /
Hold All Outputs (hold actual values, not display and Totalizers) /
Hold Output Y (hold actual values) /All Outputs To Zero (actual values = 0%, not display and
Totalizers) /
Output Y To Zero (actual value = 0%) /
All Totalizers (reset all Totalizers to “0”) /
Totalizer “Z” Reset (set Totalizer 1, 2 or 3 to “0”) /
Stop All Totalizers /
Stop counter “Z” (stops counter 1, 2 or 3) /
Zero Outp.+Stop Tot. (all outputs 0%, stop all Totalizers, not the display) /
External Range Y (control input for external range of current output Y) - also make this
setting on current output Y (no check if current output Y is available) /
Error Reset (all resettable errors are deleted) /
Calibrate Zero
C3._.2
Invert Signal
Select:
Off (activated output: switch closed) /
On (activated output: switch open)
C3._.3
Information
Serial no. of the I/O board, software version no. and production date of the circuit board
C3._.4
Simulation
Sequence see B1._ Control Input X
6.4 Function tables
6.4.3 Menu C, Setup, continued
