56
206-4218
Configuration Options via Command Line (Cont.)
(Continued from previous page)
2. At the prompt for confirmation, either:
• Type
y
and press
Enter
if you want to run an RF scan. Continue with step 3.
• Type
n
and press
Enter
to return to the Setup Command prompt without scanning for RF
channels.
3. At the
Enter tuner for VHF scan [1] >
prompt, either press
Enter
to accept the
default value in square brackets, or type the number of the tuner on which to run the VHF
scan, and then, press
Enter
.
4. At the
Enter tuner for UHF scan [1] >
prompt, either press
Enter
to accept the
default value in square brackets, or type the number of the tuner on which to run the UHF
scan, and then, press
Enter
.
Once you specify the tuner for the UHF scan, the system will display the following reminder
before initiating the scan:
This will take several minutes to complete. Please be patient.
When the scan is complete, the system displays a listing of the channels and programs found
for the selected tuner(s), for example:
Channel scan completed successfully.
Scan found a total of 10 channels.
Channel 7 programs: 1 2 3
Channel 12 programs: 1
Channel 17 programs: 3 5
Channel 19 programs: 3 4
Channel 21 programs: 1 2 3
Channel 27 programs: 3 4 5 6 7
Channel 36 programs: 1 2 4
Channel 43 programs: 3 4 5 100 101 200 209 300 301 302
Channel 44 programs: 1 2 3
Channel 47 programs: 3 4 5 6 7 8
Configure the IP Output
IP Output Configuration Menu options enable you to view and/or modify the IP output
configuration for your system. Each of the menu options is described on the pages that follow.
Note:
Ensure the output mode also has been set accordingly. See “Set the Output Mode” on
page 49 for further information.
Access the IP Output Configuration Menu
1. At the
Setup Command >
prompt, type
ipout
and press
Enter
.
2. At the
IP Output Command >
prompt, either:
• Press
Enter
to display the IP Output Configuration Menu (see example on following page).
• Type the desired command and press
Enter
.