47
206-4218
(Continued from previous page)
Note:
If the system is set for RF 64-QAM output, the stream number prompt (see step 2) will
allow only four stream options. Streams 1, 2, 3, and 4 are configured by default when 64-QAM
output is used, though any four of the OAT100R tuners may be mapped to these streams.
1. At the
Tuner Command >
prompt, type
output
and press
Enter
.
2. At the
Enter output stream number (1-8 or 0 for no connect) [
#
]>
prompt,
either:
• Press
Enter
to accept the default value (i.e., the current setting) in square brackets.
• Type
0
and press
Enter
to specify “no connection.”
• Type in the appropriate stream number and press
Enter
to remap the tuner output to a
different stream.
The system will display confirmation, for example:
Output stream remapped. Tuner is now streaming on output 2.
Note:
You can run the “monitor” command, if desired, to review the system settings. Refer to
“Monitor the System” on page 44 for further information.
Power the Tuner On or Off
At the
Tuner Command >
prompt, either:
• Type
on
and press
Enter
to power ON the tuner. The system will display confirmation, for
example:
Powering on Tuner-1: OK
Note that the power ON process may take up to 90 seconds as tuner firmware is reloaded.
If desired, you can track the tuner progress via the Tuner Menu “info” command (see “View
Tuner Information” on page 43 for further information).
• Type
off
and press
Enter
to power OFF the tuner. The system will display confirmation, for
example:
Powering off Tuner-1: OK
Reset the Tuner
1. At the
Tuner Command >
prompt, type
reset
and press
Enter
.
The system will prompt for confirmation:
Do you want to reset the Tuner? [y/n]:
2. Either:
• Type
y
and press
Enter
to initiate an immediate reset of the tuner (i.e., resynchronize the
tuner on the input stream). Note that a tuner reset may take up to 15 seconds.
• Type
n
and press
Enter
to return to the Tuner Command prompt without resetting the tuner.
Configuration Options via Command Line (Cont.)