44
206-4218
Note:
When a tuner is powered ON from a power OFF state, the Status field of the Tuner
Information display reflects the progress of the power ON process, which may take up to 90
seconds as tuner firmware is reloaded. During the power ON process, the Status field shows
“Initializing,” and once the process is complete, the Status field shows “Streaming.” A viewable
stream appears 10 to 15 seconds after the tuner status changes to “Streaming.”
Monitor the System
This option enables you to view static or dynamic system streaming data and is also available
from the OAT100R Main Menu and the Setup Menu.
At the
Tuner Command >
prompt, either:
• Type
monitor
and press
Enter
to display the current system data (see sample display
under the “Monitor the System” section on page 40).
• To monitor streaming data in real time, type
monitor
and the number of seconds before
the data refreshes. Then, press
Enter
. For example, to refresh the data every second, type
monitor 1
and press
Enter
.
When you are finished monitoring streaming data, press
Enter
to stop the system monitor
and return to the
Tuner Command >
prompt.
View the System Program Map
This option enables you to display program assignments for each tuner and is also available
from the OAT100R Main Menu and the Setup Menu.
At the
Tuner Command >
prompt, type
map
and press
Enter
to display the current system
program assignments (see sample display under the “View the System Program Map” section
on page 41).
Set the Tuner Channel
The terrestrial channel range is 2 to 69.
1. At the
Tuner Command >
prompt, type
channel
and press
Enter
.
2. At the
Enter channel [#]>
prompt, either:
• Press
Enter
to accept the default value in square brackets, or
• Type in a new channel number and then press
Enter
.
Note:
If you enter channel “1” or a channel number that is higher than “69,” the system will
display an “invalid channel” message and then return to the
Tuner Command >
prompt.
Note:
To specify “no connection,” type
0
at the channel prompt and press
Enter
.
Configuration Options via Command Line (Cont.)
(Continued on next page)
