Appendix C
RV-8
C-6
Auto Scan With Three-Digit Number
You can also program the remote control by sending out a series of
Power Off commands for different brands stored in the library by
using the following steps. This is similar to the first method, except
it is easier to move through all of the device codes for your device
and make note of each one that turns your device OFF.
To program the remote to make it compatible with other com-
ponents:
1. Manually turn on the device you plan to operate.
2. Go to the SETUP mode by pressing both the HOME and ENT
buttons simultaneously for three seconds.
3. Press the P-PRO button next to the LCD screen.
4. The remote will be flashing “SELECT BUTTON.” Press the
device you wish to program. (For example, to program TV,
press the TV button.)
5. The remote will be flashing “FROM TABLE.” Select the device
from which the scanned code will be selected. (Important: If
you have already relabeled your device keys, the LCD screen
will not look like the illustration on page C-5. Select the appro-
priate LCD button for the “FROM TABLE” using the labels as
shown in the illustration on page C-4. For example, if you have
relabeled PHONO as LIGHTS, you would still push the bottom
right button to access the AUX Code Table.)
6. Point the remote control toward the component and press
either the UP or DOWN button on the LCD. (It will send out a
series of Power Off codes when the button is kept pressed and
the code numbers that are being sent are shown on the LCD.)
If the right code number is sent, the component will turn off
right after the code number is transmitted.
7. Release the UP or DOWN button as soon as the device is turned
off. If you passed the one that turned off the device, manually
turn the device back on, and reverse your UP or DOWN one
device). If the device turns off when the three-digit code is
entered, make note of the code. It will have at least some of the
functions in it that are needed to control the device.
8. Confirm that it is the right code by pressing the Power button.
The device should turn on. After it is confirmed that the right
code is entered, save the code by pressing the SAVE button on
the LCD.
9. At this point try ALL of the buttons on the remote, and see
which ones work with the device. The majority of the buttons
should work with the device. Make note of the code if it seems
to be the right one, and try the next one. You are trying to find
the one that has the most functions to operate your equip-
ment. If there are any functions missing, you will learn them
from your original remote in the “Using Learning Method”
section on page C-7.
10. Continue to program other components by repeating from
Step 1 above.
11. Press EXIT at any time to stop the procedure.
12. When you are finished programming the remote, exit from the
preprogramming mode by pressing the HOME button and
then exit from the SETUP mode by pressing the HOME button
once again.
Note:
A programmed code for each device can be changed
at any time by using the preprogrammed method
which starts on the previous page . A new code will
override an old code. For example, this would be done
if a TV is replaced with a new TV. The code table for
Laserdisc is stored under DVD2. The code table for
cable box is stored under Zone 2. The code table for
cassette player is stored under Zone 3.
Summary of Contents for RV-8
