Lexicon RV-8, User Manual

Page: 29 / 238

Basic Operation
RV-8
2-11
Tuner Overview
(continued from page 2-10)
Scan Mode
Scan Mode will scan through all available stations, pausing for 2
seconds on each station before scanning to the next one. To enter
Scan Mode, press and hold one of the
Tune/Seek buttons
( Tune/Seek ) ( or on the remote control) until the
display shows SCAN or SCAN . To stop scanning, press either
Tune/Seek button.
Loading Presets
To load a preset:
Enter a preset number between 1 and 40 using the front-panel or
remote control number buttons. The display will show “Loading
Preset.” If a third digit is entered, the tuner will switch over to
Direct Station Access mode and the front-panel display will show
”Setting Frequency.”
To skip through available presets in order:
Press the or buttons on the remote control. If, for example,
preset 1 is loaded and the button is pressed, the RV-8 will load
preset 2 (or the next available preset). If preset 1 is loaded and the
button is pressed, the RV-8 will load preset 40 (or the next avail-
able preset).
Note:
This feature is only accessible via the remote control.
Saving Presets
The RV-8 has 40 presets available for storing AM or FM stations.
The presets are divided into four banks with ten presets per bank.
It is possible to store a combination of AM and FM stations in each
bank. Storing presets on the RV-8 can be accomplished from either
the front-panel or the remote control. The operation is identical.
To save a station to a preset on the RV-8:
Press the SAVE button on either the front-panel or remote control.
”Saving Preset” will appear on the front-panel. Entering a number
between 1 and 40 will store the currently loaded frequency into the
corresponding preset. For example, if the tuner is currently playing
101.7FM, pressing the
SAVE button, then the 1 button will store
101.7FM into preset number 1. Pressing the 1 button followed by
the 5 button will store into preset number 15. Pressing more than
two numbers will reset the preset number to the third digit that
was entered.
Pressing the SAVE button a second time will cancel the saving
process.
Editing Presets
It is possible to customize the name of each preset on the RV-8.
To edit the preset name:
1. Navigate to the TUNER PRESET menu (MAIN MENU TUNER
PRESETS). Within the TUNER PRESETS menu is a list of preset
pages. PAGE 1 contains presets 1 through 10, PAGE 2 contains
presets 11 through 20, etc.
2. Select the Page that contains the desired preset. Once the
PAGE menu has been selected, a list of presets will appear.