Lexicon RV-8, User Manual, Page: 18 / 238

Getting Started
Lexicon
1-6
2. Remove old batteries inserted in the compartment (if app-
licable).
3. Insert four AAA batteries in the compartment as shown in Step
3 in the illustration below. Make sure the batteries are correctly
inserted observing the proper polarity.
4. When new batteries have been installed, close the battery com-
partment cover as shown in Step 4. To do this, align the cover
with the guide on the back of the remote control. When the
cover is aligned, press the cover until it snaps into place. The
remote control starts up automatically.
5. Dispose of the old batteries (if applicable).
REMOTE CONTROL BATTERY INSTALLATION
The remote control requires four AAA batteries that should be
replaced as needed. It is recommended that you use Alkaline
batteries, which last longer without leaking. When the batteries are
low on power, the remote control enters a low-voltage condition
that prevents it from operating the RV-8. When this occurs, follow
the instructions below to replace the batteries. Normal operation
will resume when the new batteries are installed. Memory settings
will not be lost when the batteries are replaced.
To replace the remote control batteries:
1. Locate the battery compartment on the back of the remote
control. Then remove the battery compartment cover as
shown in the illustration below. To do this, press the tab
attached to the cover (Step 1). When the tab is pressed, pull
the cover away from the remote control (Step 2).
1
2
3
4