Lexicon RV-8, User Manual, Page: 120 / 238

AUDIO CONTROLS
Lexicon
4-4
TILT EQ
-3.0dB to +3.0dB
Controls the amount of tilt equalization applied to the Main Zone
speaker and audio output connectors labeled Front L/R, Center and
Sub. This parameter setting affects the entire frequency spectrum
with a hinge point at 1kHz. As the setting is increased,
frequencies higher than 1kHz are boosted, while frequencies lower
than 1kHz are simultaneously cut. As the setting is decreased,
frequencies higher than 1kHz are cut, while frequencies lower than
1kHz are simultaneously boosted. The graph shown on the left of
the next page illustrates the frequency response of TILT EQ param-
eter settings.
TILT EQ AUDIO CONTROLS
AUDIO CONTROLS
(continued from page 4-3)
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
TUNER PRESETS
SETUP
AUDIO CONTROLS
AUDIO CONTROLS
BASS +0.0dB
0.0dB
TILT EQ
+0.0dB
LOUDNESS OFF
BALANCE
<|>
FADER <|>
ZONE2 BALANCE <|>
ZONE3 BALANCE
<|>
TILT EQ +0.0dB
-3.0 to +3.0dB MAIN MENU
MODE ADJUST
AUDIO CONTROLS
TUNER PRESETS
SETUP
AUDIO CONTROLS
AUDIO CONTROLS
BASS +0.0dB
0.0dB
TILT EQ
+0.0dB
LOUDNESS OFF
BALANCE
<|>
FADER <|>
ZONE2 BALANCE
<|>
ZONE3 BALANCE <|>
LOUDNESS OFF
ON
OFF
LOUDNESS
ON, OFF
Controls the amount of low-frequency boost that is automatically
applied to the Main Zone speaker and audio output connectors
labeled Front L/R, Center and Sub. When set to ON, loudness com-
pensation is automatically applied based on volume level. As vol-
ume level increases, the amount of boost automatically decreases.
The loudness contour is optimized for sources calibrated to THX
reference levels. When set to OFF, no loudness compensation is
applied. The graph shown on the right of the next page illustrates
the frequency response that is automatically applied when the
LOUDNESS parameter is set to ON and Main Zone volume level is
adjusted.
Note:
The graph on the following page shows the Loudness
parameter settings between -30dB and 0dB in one-dB
steps. The topmost line represents the curve at
-30dB.
LOUDNESS AUDIO CONTROLS