Lexicon RV-8, User Manual

Page: 194 / 238

Appendix C
Lexicon
C-7
press at a time, until the unit turns off. There is no way of
knowing which code is the one that will have the functions that
more closely match the device than the others, so it is advised
to try them all. See Step 9 below. (Press the UP or DOWN
button within 20 seconds of beginning programming; other-
wise the remote will revert to the SETUP menu, and then after
a period of time, it will go back to the MAIN device page.) If
there is more than one code number assigned to your brand,
try one code number at a time until the correct code number
is found (the number that turns off the device). If the device
turns off when you enter the three-digit code, make note of the
code. It will have at least some of the functions in it that are
needed to control the device.
8. Confirm that it is the right code by pressing the Power button.
After ensuring that the right code is entered, save the code by
pressing the SAVE button on the LCD.
9. Confirm that the right code number that matches the compo-
nent was entered by pressing other functional buttons. If any
of the buttons do not operate as they should, repeat from
step 1.
10. Continue to program other components by repeating from
step 1 (previous page).
11. Press EXIT at any time if you do not wish to proceed.
12. Exit from Preprogrammed mode by pressing the HOME button
and then exit from the SETUP mode by pressing the HOME
button once again.
Using Learning Method
The RV-8 remote can be programmed to operate a device by
“teaching” the correct commands to the device buttons on the
main screen menu; to the two sub-pages within each device but-
ton; to the 31 buttons and the joystick located in the middle of the
remote control. The RV-8 remote learns these commands by receiv-
ing infrared signals directly from your existing remote controls. The
RV-8 remote receives these signals through its learning eye, locat-
ed at the top of the unit.
Apart from the PAGE, HOME and FAV buttons, which cannot be
taught, the RV-8 remote has the capability of learning up to 530
commands.
Note:
Function buttons are buttons that can be assigned a
command to control a particular action for a device.
Commonly used function buttons include the 2 pages
of sub-commands within each of the 10 devices:
channel up/down, volume up/down, menu, guide,
exit, info, digits 0-9 and the center of the joystick
(thumbpad).
Do not edit the Main, Zone 2 or Zone 3 buttons. Doing so will
remove RV-8 control.
CAUTION