Leuze BCL604i, Operating Instructions Manual

Page: 91 / 127

Starting up the device - Configuration
Leuze electronic BCL 604i 91
Parameter length
23 byte
Input data
None
Output data
None
Comment
The DC bias level also defines whether the output is low-active (0) or high-active (1).
Switching on an I/O configured as an output means switching to the active state; switching off, on the other
hand, results in switching to the inactive or idle state.
10.12.9Module 74 – SWIO status and control
Description
Module for handling switching input and switching output signals.
Parameter
None
Input data
Table 10.52: Input data for module 74 Input/output status and control
Minimum switch-on
time
The parameter defines a minimum time period
before the signal is reset.
18 UNSIGNED16 0 … 65535 0 ms
Delay off time The parameter defines a time delay for the sig
-
nal during switch-off.
20 UNSIGNED16 0 … 65535 0 ms
Input function The parameter specifies the function which is
to be activated or deactivated by a change of
state in the signal.
22 UNSIGNED8 see chapter 10.12.4 0 -
Parameter Description Addr. Data type Value range Default Unit
Parameter Description Addr. Data type Value range Init value Unit
State 1 Signal state of switching input or output 1 0.0 Bit 0.1 0 -
State 2 Signal state of switching input or output 2 0.1 Bit 0.1 0 -
State 3 Signal state of switching input or output 3 0.2 Bit 0.1 0 -
State 4 Signal state of switching input or output 4 0.3 Bit 0.1 0 -
Comparison state
switching output 1
(Event Counter)
Indicates whether the event counter has
exceeded the set comparative value.
The bit is reset to the init. value by resetting
the event counter.
1.0 Bit 0: Not exceeded
1: Exceeded
0 -
Switching output 1
Comparison state tog
-
gle bit
(Event Counter)
If “SWOUT switches several times” was con
-
figured as comparison mode, this bit is toggled
each time the event counter is exceeded.
The bit is reset to the init. value by resetting
the event counter.
1.1 Bit 0 -> 1: Event counter
exceeded
1 -> 0: Event counter
exceeded again
0 -
Comparison state
switching output 2
(Event Counter)
Indicates whether the event counter has
exceeded the set comparative value.
The bit is reset to the init. value by resetting
the event counter.
1.2 Bit 0: Not exceeded
1: Exceeded
0 -
Switching output 2
Comparison state tog
-
gle bit
(Event Counter)
If “SWOUT switches several times” was con
-
figured as comparison mode, this bit is toggled
each time the event counter is exceeded.
The bit is reset to the init. value by resetting
the event counter.
1.3 Bit 0 -> 1: Event counter
exceeded
1 -> 0: Event counter
exceeded again
0 -
Comparison state
switching output 3
(Event Counter)
Indicates whether the event counter has
exceeded the set comparative value.
The bit is reset to the init. value by resetting
the event counter.
1.4 Bit 0: Not exceeded
1: Exceeded
0 -