Starting up the device - Configuration
Leuze electronic
BCL 604i
85
10.12.3Switch-on and switch-off functions for operation as an output
The following options are available for switch-on and switch-off functions in the “output” operating mode:
Table 10.46:
Switch-on/switch-off functions
10.12.4Input functions for operation as an input
Table 10.47:
Input functions
Name
Value
Comments
No function
0
No functionality
Reading gate start
1
Reading gate end
2
Positive reference code comparison 1
3
Negative reference code comparison 1
4
Valid read result
5
Invalid read result
6
Device ready
7
The device is in a ready state.
Device not ready
8
The device is not yet ready (motor and laser are being activated).
Data transmission active
9
Data transmission not active
10
AutoControl good quality
13
AutoControl bad quality
14
Reflector detected
15
Reflector not detected
16
External event, pos. edge
17
In the PROFIBUS case, the external event is generated with the aid of
module 74 – “I/O status and control”, see chapter 10.12.9 "Module 74 –
External event, neg. edge
18
See above
Device active
19
Decoding is currently being performed.
Device in standby mode
20
Motor and laser inactive.
No device error
21
No error was detected
Device error
22
Device is in an error state.
Positive reference code comparison 2
23
Negative reference code comparison 2
24
Name
Value
Comments
No function
0
No functionality
Activation of the reading gate
1
Reading gate deactivation only
2
Reading gate activation only
3
Reference bar code teach-in
4
Start/stop autoconfiguration mode
5
