Leuze BCL604i, Operating Instructions Manual, Page: 58 / 127

Starting up the device - Configuration
Leuze electronic BCL 604i 58
Parameter
Table 10.7: Parameters for modules 1-4
Parameter length
8 bytes
Input data
None
Output data
None
10.6.2 Module 5 – Code type features (symbology)
Description
The module defines extended features for various code types.
Parameter Description Rel. Addr. Data type Value range Default Unit
Code type Released code type; no code means that all
subsequent code tables are also deactivated.
The valid number of digits also depends on the
code type.
0.0 … 0.5 BitArea 0: No code
1: 2/5 Interleaved
2: Code39
3: Code32
6: UPC, UPCE
7: EAN8, EAN13
8: Code128
10: EAN Addendum
11: Codabar
12: Code93
13: RSS-14
14: RSS Limited
15: RSS Expanded
0 -
Number-of-digits
mode
Interpretation of the number of digits. 1.6 Bit 0: Enumeration
1: Range
0 -
Digits 1
a)
Decodable number of digits; in the case of a
range, this number defines the lower limit.
1.0 … 1.5 UNSIGNED8 0 … 63 0 -
Digits 2 Decodable number of digits; in the case of a
range, this number defines the upper limit.
2 UNSIGNED8 0 … 63 0 -
Digits 3 Decodable number of digits in the enumeration
mode.
3 UNSIGNED8 0 … 63 0 -
Digits 4 Decodable number of digits in the enumeration
mode.
4 UNSIGNED8 0 … 63 0 -
Digits 5 Decodable number of digits in the enumeration
mode.
5 UNSIGNED8 0 … 63 0 -
Reading reliability Min. reading reliability to be achieved in order
to output a read code.
6 UNSIGNED8 1 … 100 4 -
Check digit proce
-
dure
Used check digit procedure. 7.0 … 7.6 BitArea 0: Standard check digit
evaluation
1: No check digit verifica
-
tion
2: MOD10 Weight 3
3: MOD10 Weight 2
4: MOD10 Weight 4_9
5: MOD11 Cont
6: MOD43
7: MOD16
0 -
Check digit output Turns the check digit output on or off. Standard
means that the check digit is transmitted
according to the applicable standard for the
selected code type.
If no check digit transmission is intended for
the selected code type, then “Standard” means
that the check digit is not transmitted and “Not
Standard” means that the check digit is trans
-
mitted anyway.
7.7 Bit Check digit output
0: Standard
1: Not standard
0 -
a) Refer to the notice on the number of digits (see chapter 10.4.4 "Permanently defined parameters/device parameters").