Leuze BCL604i, Operating Instructions Manual

Page: 87 / 127

Starting up the device - Configuration
Leuze electronic BCL 604i 87
Parameter length
23 byte
Input data
None
Output data
None
Comment
The DC bias level also defines whether the output is low-active (0) or high-active (1).
Switching on an I/O configured as an output means switching to the active state; switching off, on the other
hand, results in switching to the inactive or idle state.
10.12.6Module 71 – Switching input/output SWIO2
Parameter
Table 10.49: Parameters for module 71 – Input/Output 2
Minimum switch-
on time
The parameter defines a minimum time period
before the signal is reset.
18 UNSIGNED16 0 … 65535 0 ms
Delay off time The parameter defines a time delay for the sig
-
nal during switch-off.
20 UNSIGNED16 0 … 65535 0 ms
Input function The parameter specifies the function which is
to be activated or deactivated by a change of
state in the signal.
22 UNSIGNED8 see table 10.47 1 -
Parameter Description Addr. Data type Value range Default Unit
Parameter Description Addr. Data type Value range Default Unit
Function This parameter defines whether I/O 2 func
-
tions as an input or as an output.
0.0 Bit 0: Input
1: Output
1 -
Mode of operation for configuration as an output
DC bias level The parameter defines the DC bias level of the
switching output and, thus, simultaneously
whether the output is low-active (0) or high-
active (1).
0.1 Bit 0: LOW (0V)
1: HIGH (+Ub)
0 -
Reserved Free 0.2 … 0.7
Start-up delay With this parameter, the output pulse may be
delayed by a set time period.
1 UNSIGNED16 0 … 65535 0 ms
Switch-on time The parameter defines the switch-on time
period for the switching output. If the value is
0, the signal is static.
3 UNSIGNED16 0 … 1300 400 ms
Switch-on function
1
This parameter specifies an event which can
set the switching output.
5 UNSIGNED8 see table 10.46 5 -
Switch-on function
2
This parameter specifies an event which can
set the switching output.
Switch-on function 1 and switch-on function 2
are OR linked.
6 UNSIGNED8 see table 10.46 0 -
Switch-off function
1
This parameter specifies an event which can
reset the switching output.
7 UNSIGNED8 see table 10.46 1 -
Switch-off function
2
This parameter specifies an event which can
reset the switching output.
Switch-off function 1 and switch-off function 2
are OR linked.
8 UNSIGNED8 see table 10.46 0 -
Comparative value
(Event Counter)
If the number of activation events of the
selected switch-on function reaches this com
-
parative value, the switching output is acti
-
vated. A deactivation event of the selected
switch-off function resets the counter.
9 UNSIGNED16 0..65535 0 -