Lenovo ThinkServer TD350 70DG, User Manual And Hardware Maintenance Manual

Page: 132 / 220

Notes:
• Depending on the model, your server might look slightly different from the illustrations in this topic.
• Depending on the model, the following devices might be installed in the optical drive bays:
– Optical drive
– Flex module with a slim optical drive installed
• Use any documentation that comes with the optical drive and follow those instructions in addition to
the instructions in this topic.
Installing or replacing an optical drive
Note: The following instructions also apply to a 5.25-inch flex module (available on some models).
To install or replace an optical drive, do the following:
1. Remove all external media from the drives and turn off all attached devices and the server. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server.
3. Remove the server cover. See “System board components” on page 44.
4. Locate the optical-drive bays. See “Front view of the server” on page 18. Read the optical drive
installation rules in “Installing or replacing a device in an optical drive bay” on page 117.
5. Depending on whether you are installing or replacing an optical drive, do one of the following:
• If you are installing a secondary optical drive into the upper optical-drive bay, insert a finger into the
hole as shown to push the protective shield until it is projected from the front of the chassis. Then,
hold the protective shield from the front and completely slide it out of the chassis.
Figure 70. Removing the protective shield of the optical-drive bay
118
ThinkServer TD350 User Guide and Hardware Maintenance Manual