LEGRAND 48DCWC-04-2X100-D0NB, User Manual

Page: 94 / 211

PRO1 Sentry Switched DC PDU
94 of 211
Network (Setting Up Network Protocols)
The Network section of the Web interface provides network setup options for the protocols supported by the
PRO1/PRO2 PDU and PRO1 DC PDU: DHCP/IP, Email/SMTP, FTP, HTTP/HTTPS, LDAP, RADIUS, SNMP, SNTP, Syslog,
, and Telnet/SSH.
Note: The Network section only allows the administrator to set up network protocol parameters.
To configure how the PDU user will access and use the network and system, see the Access section.
Network > DHCP/IP
The DHCP/IP page allows configuration of the acquisition method for the protocol stack, viewing of current
network communication settings, determining static IPv4/IPv6 address formats, and the enabling of DHCP
options.
To configure DHCP/IP:
1. Network: Determines the acquisition method used for the protocol stack: “Disabled”, “Dual IPv6/IPv4”, or
“IPv4 only”. For maximum backward compatibility, accept the default network mode “IPv4 only”.
2. View the fields in the next section of the page as a quick reference for current network parameters:
For more information about how the PDU handles the network with IPv6/IPv4 options,
see
Network-Enabled Modes in this user guide.
To configure static IPv4/IPv6:
1. IPv4/IPv6 Address/Gateway: Provide the address for these fields in either IPv4 or IPv6 format.
2. IPv4 Subnet Mask: If IPv4 is used, supply the IP address for the subnet mask in IPv4 format.
3. Primary/Secondary DNS: Provide the IP address for the primary and secondary DNS hostnames.