Lauda Proline RP 1290 C, Operating Instructions Manual

Page: 100 / 120

Proline Edition X cooling thermostats
100
Maintenance
YACE0100
/
October 4, 2018
9 Maintenance
9.1 Cleaning
Withdraw the equipment mains plug before cleaning.
Cleaning can be carried out with water to which a few drops of surfactant (washing-up liquid) have been
added and using a damp cloth.
No water must enter the control section.

Carry out appropriate decontamination if hazardous material is spilt on or in the
equipment.
The cleaning or decontamination method is determined by the user's specialist
knowledge respectively the corresponding data sheets. In case of doubt, contact the
manufacturer of the hazardous material.
9.2 Device status
The thermostat can be conveniently checked with the Command remote control. Some values can
however also be interrogated in the Master version.
9.2.1 Interrogating the device type

MNEmv

PArB.

tYPG
. (

7.5)

Settings

Device status

Device type
With low temperature thermostats, the device type is detected automatically and cannot be changed.
9.2.2 Software version

MNEmv

ShoWX

UEr
(

7.5).
Here, only the version of the control system in the Master is displayed.

Settings

Device status

Software version .
With the Command remote control the versions of the control system ( Control ), safety system
( Safety ), Command remote control ( Command ), cooling system ( Cool ) and, where applicable, other
connected modules are displayed.
9.2.3 Serial numbers

MNEmv

ShoWX

Snr H
and
Snr L
(

Section 7.5).
Under
Snr H
the first five places of the ten-character serial number of the Master device are displayed.
Under
Snr L
the last five places are shown.

Settings

Device status

Serial numbers .
With the Command remote control the serial number of the Master ( Master ), Command remote control
( Command ), cooling system ( Cool ) and other connected modules are displayed.