Lauda Proline RP 1290 C, Operating Instructions Manual

Page: 37 / 120

Proline Edition X cooling thermostats
YACE0100 / October 4, 2018
Starting up
37
7.7 Important settings
7.7.1 Temperature setpoint setting
The setpoint is the temperature, which the thermostat should reach and maintain constant.
Master (main level)
SEt

Press key until
SEt
(Setpoint) appears.

Press, display flashes.
or

Enter the setpoint with the two keys (

Section 7.4.1 General key
functions and pilot lamps).
Wait 4 seconds or

Display flashes 4 seconds

new value is automatically accepted,
or
value is accepted immediately with Enter key.
 
For safety reasons the setpoint can only be set up to 2 °C above
upper limit of the operating temperature range for the relevant
device type.

In the following cases, the manual setpoint entry is blocked:
Setpoint is taken from the analog module, from the programmer in
the Command remote control or via the serial interface.

When the setpoint temperature is to be lowered, it may take up to
one minute before the blue LED lights.