Lapierre 3 FPS2 X-Control, Owner'S Manual

Page: 42 / 121

SPECIFIC MODELS - 17
the AcS plate in direct contact with the teeth of the chainring, studs, etc. However, if the plate is too far away
from the teeth, the chain may get stuck.
7 ChANgINg ThE hEAD ANgLE / Dh 2011
Steps to follow :
1- Remove the eccentric LAPIERRE pressed cup.
2- turn the two cups in the frame ½ a turn to change the head angle, then insert the cups.
3- the mark on the cups will allow to read the angle on the current angle.
Head angles:
63.5° + 0.5° = 64° or 63.5° - 0.5° = 63°
Warning
: the two cups must be mounted with the two marks showing the same head angle!
8 INTEgRATED SEAT POST TIghTENINg SySTEM /RAPT 2.1/RAPT 2.2/Dh 2011
completely integrated in the top tube, this tightening system is composed of two biting pieces activated by
an allen/hex bolt. As it presses the seat tube this one stays in the desired place. there is also a significant
reduction on weight and the advantage of avoiding the possibilities of rips or accidents.
Steps to follow :
1- Insert the seat post in the frame.
2- Insert the biting pieces and the bolt as shown in the picture.
3- Standstill the seat post on the desired position and screw the bolt, torque 10-11 Nm.
III - SPECIFIC MODELS
EN
g
LIS
h