26
28-0724/02
5. Mix the cleaning solution. Put a portion of the solution into a spray bottle. Soak the
lower chute in the remaining solution.
6. Spray the upper chute with the cleaning solution.
7. With a soft sponge, clean the inside of the upper and lower chutes.
8. Rinse the lower chute thoroughly.
9. Dry the lower chute thoroughly.
10. Empty the cleaning solution from the spray bottle, then refill with plain water. Rinse
the upper chute thoroughly.
11. Dry the upper chute.
12. Reinstall the lower ice chute onto the upper chute, then reinstall the spring.
13. Reinstall merchandiser.
14. Reconnect power to the dispenser.
2.5
ICE BIN CLEANINg - PERFORM AT START UP AND MONTHLY
1. Disconnect dispenser from power source.
2. Remove top cover.
3. Remove agitator pin from agitator shaft (see photo below). Slide agitator shaft
rearward out of motor shaft and pull out of rear bearing to remove.
4. Remove dispensing wheel from motor shaft by sliding rearward.
5. Remove dispensing wheel shroud.
6. Remove splash plate assembly by lifting it up and out from the dispenser face.
7. Using cleaning solution described in Section 2.2 and a clean cloth or soft brush,
clean all removable parts, sides of ice bin, ice chute, and surface of aluminum
casting.
8. Repeat Step 7 for all exterior surfaces of the dispenser.
9. Using hot water, thoroughly rinse away the cleaning solution.
10. Wearing sanitary gloves, soak a clean cloth towel in sanitizing solution described in
Section 2.2, and wash all surfaces of removable parts, sides of ice bin, ice chute,
and surface of aluminum casting.
11. Using hot water, thoroughly rinse away the cleaning solution.
12. Repeat Step 10 for all metal and plastic surfaces (but not labels) of the dispenser
exterior.
13. Wearing sanitary gloves, reassemble all removable parts. Ensure agitator clip is
locked:
14. Fill unit with ice and replace top cover.
15. Reconnect dispenser to power source.
Summary of Contents for BEVARIETY MCY-22
