laguna S45T, Manual, Page: 58 / 80

Page 58 of 60
CHAPTER 5. MAINTENANCE
Before any maintenance/lubrication works, the electricity power should be shut off to avoid any involuntary
retstart.
5.1 LUBRICATION
Do not operate machine until properly lubricated.
Apply a drop of light machine oil occasionally on the ledge and wall of the table opening to facilitate the
changing of table rings.
The bearings in the motor are sealed for life and do not require
lubrication.
The spindle bearings should be lubricated every 200 hours of use by using
the grease gun (A) Fig.5.1, supplied.
Two grease fittings, one of which is shown at (B), are supplied on the
spindle housing for this purpose. The other grease fitting is directly
opposite fitting (B). Before lubricating, clean grease fittings (B) thorough
and lubricate the spindle bearings with two pumps of one of the following
greases:
Fig. 5.1
Shell Alvania grease R2
Dow Corning MolyKoke R BR2
Esso-Becon 2
Mobile-Mobilplex 47
Texaco-Startex 2
SUGGESTED CHECKING
Index position Interval / Situation
Spindle ball bearings Every 200 hours of use
Belt Every 1000 hours of use or check belt whenever get frayed
Emergency stop Every day/ by functional test-press checking
Interlocked guards
Every day/ by opening each guard in turn to stop the machine and by proving the
inability to start the machine with each guard in the open position
The mechanical brake
Every 100 hours of an operation use or by brake function testing to check that the
machine is braked within the specified time (less than 10 sec)
Electrical cabinet/system Monthly check: wiring terminals loosening, insulation deterioration
《
NOTE
》
After a set/or adjustment/or repair work or a trouble shooting, please check the safety relevant
functions whether normal or not before a use.
5-1