laguna S45T, Manual, Page: 36 / 80

Page 36 of 60
3.10 ASSEMBLING AND INSTALLING FENCE AND DUST CHUTE
ASSEMBLING FENCE
1. Place fence body (A) Fig.3.23 on the table. Fasten bar (C) to
the front of the fence half using the locking lever (B) and
washer. Assemble the remaining bar to the fence half in the
same manner.
《
NOTE
》
Locking levers (B) are spring-loaded and can be
repositioned by pulling out the handle and
repositioning it on the nut located underneath the hub of the handle.
Fig.3.23
2. Locate the two fence locking handles (D) Fig. 3.24 and
washers, and fasten fence body (A) to one of the two sets of
holes located on the machine table.
3. Loosen locking lever (B) Fig.3.23, and slide rear of fence half
(E) Fig. 3.24 onto locking bar (C) Fig, 3.23. Assemble
remaining fence half in the same manner. Then tighten
locking lever (B).
4. Assemble top cover (F) Fig.3.24, to top of fence body using
the two locking knobs (G) and washers.
Fig.3.24
ASSEMBLING GUARDS TO FENCE BODY
1. Assemble spring guard (A) Fig.3.25, hold-down (D) and
clear plastic guard (C) to mounting rod (D) located on top of
fence cover or fence body using rod (E) and clamps.
2. The spring guard (fence pressure pad) (A), hold-down (table
pressure pad) (B) and clear (C) can be flipped up out of the
way when not in use or when making adjustments.
Realignment of fence plates parallel:
Placing a solid ruler along the fixed fence plate, adjust the movable
Fig.3.25
fence plate to contact the fixed fence plate.
FENCE CONTROLS AND ADJUSTMENTS
《
WARNIING
》
The fence halves (E) Fig3.24 should be adjusted endwise so the opening at the spindle is
never more than is required to clear the cutter.
1. To adjust the fence halves (E) Fig.3.24 endwise, loosen the two fence locking levers, slide the fence
halves to the required positions and tighten locking levers (B).
3-12