
Page 40 of 60
3-15
Miter gauge clamp
A clamp (E) Fig.3.35 is supplied with your miter gauge to securely hold
workpieces when shaping small piece across the gain.
The clamp (E) can be moved up or down as required on post (F).
Fig. 3.35
Stop fence for silding table (optional)
1. Insert two nuts (A) Fig.3.36 of locking levers (B) into fence
channel (C).
2. Position fence (E) Fig.3.37 on miter gauge with two screws
(D) Fig.3.36 of locking levers engaged into two notch (F)
Fig.3.37 on top of miter gauge.
3. To slide fence (E) Fig.3.37, to the left or right, loosen locking
levers (B), slide fence (E) to the desired position and tighten
locking levers (B). To tilt the fence (E), loosen locking
handle (G).
Fig. 3.36
A scale (H) is provided to indicate the miter angle of the fence
(E).
4. Loose locking levers (I) Fig.3.38, and insert nut (J) of stock
stop assembly into channel on end of fence as shown.
5. Slide stock stop (K) Fig.3.39, to desired position on fence and
tighten locking levers (I).
Fig. 3.37
Fig. 3.38 Fig. 3.39
Summary of Contents for S45T
