laguna S45T, Manual, Page: 38 / 80

Page 38 of 60
3-13
3.11 ASSEMBLING MITER GAUGE AND CLAMP
ASSEMBLING MITER GAUGE
For 5-speed spindle moulder with fixed table
1. Locate the miter gauge bar (A) Fig.3.28, and
insert washer and (B) of bar into T-slot (C) of
machine table.
2. Fig.3.29 illustrates the miter gauge bar (A) in the
table slot. Place the miter gauge (D) on the bar
with stud (E) of bar protruding up through
opening in miter gauge body as shown. Fasten in
place using washer (F) and lock knob (G).
Fig. 3.28
Fig. 3.29
For 5-speed spindle moulder with sliding table
1. Insert post (A) Fig.3.30 of the clamp assembly
down through hole (B) of the miter gauge body (C),
and threat post (A) into hole (D) of sliding table.
2. Insert shaft of locking handle (E) down through
opening (F) of miter gauge and thread shaft into
hole (G) of slogging table.
Fig. 3.30