
Page 52 of 60
3.3 Follow steps 3.2 (a) and (b) to enter additional presets for each MODEL and STEP (section) . After
all settings are made press the "RUN" key and the spindle height setting is ready to run.
4.
HOW TO SEARCH PREVIOUS SETTINGS TO SET UP/CHECK THE SPINDLE HEIGHT
IN SYSTEM:
4.1 Press the "MODEL" key and the column of MODEL will flash. Then, press "ENT" or enter the
desired group number.
Press the "ENT" key again.
4.2 Press the "STEP" key and the column of STEP will flash. Then, press the "ENT" or enter the section
number that you need.
Press the "ENT" key again.
5
SETTING THE ZERO REFERENCE POINT:
5.1 Press the "EDIT" key to get into edit status (flashing L.E.D.)
5.2 Press the "PARAM" key. When "P-" is in the MODEL column, the machine in the mode to edit
parameter settings. The value at the SETTING VALUE will flash.
5.3 Using the "NEXT" key scroll through the parameters until at parameter setting 6. Change this digit to
"0 "and press the "ENTER" key. Then, press the "PARAM" key and press the "RUN" key again to
complete setting the Zero Reference Point
6 PRESETTING
PARAMETERS
Parameter Description
Unit
Preset value by
manufacturer
Recommended
value
1
Locking time for shaft sleeve
(unavailable)
0.01sec 0
0
2
Pre-setting time for spindle up
0.1mm
7
5-8
3
Pre-setting time for spindle down
0.1mm
15
10-20
4
Spindle lifting motor running time for
positioning
0.01sec 3~4
2~4
5
Spindle lifting motor intermission time
for positioning
0.01sec 25
10-25
6 Encoder
reset
0.1mm
0
----------
3-28
Summary of Contents for S45T
