laguna S45T, Manual, Page: 18 / 80

Page 18 of 60
11. Curved work
A jig shall be used for all curved work unless the nature of the operation
makes it impracticable; that is where the workpiece is so large that the
addition of a jig would make the job unmanageable, or where the workpiece
is so small, or so complicated that it cannot be held securely in a jig.
Please buy the safety guard for curved work with a profession manufactures
which products
are in compliance with of relevant (CE) regulations
, such
as Suva (French), Aigner (German) etc.
Fig. 1.1.10
12. Bevel cutting
Where bevel cutting is done firm support shall be provided either by a miter gauge or by an adjustable false
fence. Push sticks shall be used at the end of the cut.
13. Glass bead work
This machine is not designed / equipped with glass bead unit for glass bead
work. Please do not install the special equipment for glass bead work.
Fig. 1.1.11
14. Other work
Where other work is produced on a machine i.e. tenon or comb joints, proprietary jigs or work holders must be
used to reduce the risk of accident.
Use of safety appliances
The following appliances may be used to assist the operator when machining:
-jigs or work holder
-push sticks
-demountable power feed
-extension tables
-lead in guide
15. Noise reduction
a) The condition of the tools are important to minimize noise levels.
b) The material and positioning of guards shall be such to reduce noise levels.
c) Selection of speed tooling shall be used to reduce the noise levels.
d) Use of personal protection equipment is not an alternative to the above.
1-15