
Page 55 of 60
CHAPTER 4. OPERATION
4.1 STRAIGHT WORK
Using the fence is the safest and most satisfactory method of shaping, and should always be used when the
work permits. Almost all straight work can be done with the fence.
1.
For normal work, where a portion of the original edge of the
stock is not touched by the cutter, both the infeed and outfeed
fences are in a straight line, as shown in Fig.4.1.
2.
When the shaping operation removes the entire edge of the
stock, e.g. in jointing or making a full bead, the shaped edge
will not be supported by the outfeed fence edge when both
fences are in line, as shown in Fig. 4.2. In this case, the stock
Fig. 4.1
should be advanced to the position shown in the Fig.4.2 and
stopped. The outfeed fence should then be moved forward to
contact the work, as shown in Fig.4.3. The outfeed fence will
then be in line with the cutting circle, and the operation can
continue.
Fig. 4.2
《
WARNING
》
Keep guards in place and in working order.
Always use fence assembly when the work
permits.
Fig. 4.3
4-1
Summary of Contents for S45T
