laguna S45T, Manual, Page: 31 / 80

Page 31 of 60
STANDARD TYPE A
1. To position the spindle in “loose spindle” (where the spindle will rotate
freely), pull out knob (A) Fig.3.10, and turn it clockwise. The knob (A)
will then be latched in “loose spindle”. Fig.3.10 illustrated the knob (A)
pulled out in the loose spindle position.
2. To engage the spindle lock, turn knob (A) Fig.3.11, counterclockwise
and push in to the locked position, as shown in Fig.3.11.
Fig. 3.10
STANDARD TYPE B
1. To position the spindle in “loose spindle (where the spindle will rotate
freely), turn knob (A) Fig. 3.10, and push in to the loose position.
2. To engage the spindle lock, pull out knob (A) and turn spindle by hand
till the spindle is locked, and then turn knob. The knob will then be
latched in “locked spindle”.
Fig. 3.11
《
CAUTION
》
Make sure spindle lock knob is in the loose position before turning “ON” the machine.
3.5 INTERCHANGEABLE SPINDLE INSTALLATION AND
REPLACEMENT
One of the features of this machine is that it can replace the different sizes of the spindle and uses router bits.
To install the spindle, proceed as follows:
FOR INTERCHANGEABLE SPINDLE WITH DRAW BAR
1. Disconnect the machine from the power source and remove
the table rings.
2. Turn the spindle raising and lowering handwheel and raise the
main shaft all the way to the top.
3.
The taper of the interchangeable spindle and the internal taper
of the shaft must be cleaned thoroughly using a cloth
moistened with kerosene or mineral spirits. Do not use
gasoline or lacquer thinner for this purpose.
Fig. 3.12
4. Thread the short threaded end of the draw bar (B) Fig. 3.12, into the threaded hole in the bottom of the
interchangeable spindle (A) and remove the two lock nuts and special bevel washer from the other end of
the draw bar (B).
3-7