Kyocera TASKalfa 7353ci, Operation Manual

Page: 136 / 723

2-69
Installing and Setting up the Machine > Command Center RX
4
Configure the settings.
Enter "SMTP" and "E-mail Send Settings" items.
5
Click [Submit].
Setting Description
SMTP Set to send e-mail from the machine.
SMTP Protocol Displays the SMTP protocol settings. Check that "SMTP Protocol" is set to
[
On ]. If [ Off ] is set, click [ Protocol ] and set the SMTP protocol to [ On ].
SMTP Server Name
*1
*1 Be sure to enter the items.
Enter the host name or IP address of the SMTP server.
SMTP Port Number Specify the port number to be used for SMTP. The default port number is 25.
SMTP Server Timeout Set the amount of time to wait before time-out in seconds.
Authentication
Protocol To use SMTP authentication, enter the user information for authentication.
SMTP Security Set SMTP security.
Turn on "SMTP Security" in "SMTP (E-mail TX)" on the
[
Protocol Settings ] page.
Connection Test Tests to confirm that the E-mail function is operating under the settings without
sending a mail.
Domain Restriction To restrict the domains, click the [ Domain List ] and enter the domain names of
addresses to be allowed or rejected. Restriction can also be specified by e-mail
address.
POP3 POP3 Protocol You don't need to set the following items when you only enable the function of
sending e-mail from the machine. Set the following items if you want to enable
the function of receiving e-mail on the machine.
Command Center RX User Guide
Check Interval
Run once now
Domain Restriction
POP3 User Settings
E-mail
Send
Settings E-mail Size Limit Enter the maximum size of E-mail that can be sent in kilobytes. When E-mail
size is greater than this value, an error message appears and E-mail sending is
cancelled. Use this setting if you have set E-mail Size Limit for SMTP server. If
not, enter a value of 0 (zero) to enable E-mail sending regardless of the size
limit.
Sender Address
*1
Specify the sender address for when the machine sends E-mails, such as the
machine administrator, so that a reply or non-delivery report will go to a person
rather than to the machine. The sender address must be entered correctly for
SMTP authentication. The maximum length of the sender address is 256
characters.
Signature Enter the signature. The signature is free form text that will appear at the end of
the E-mail body. It is often used for further identification of the machine. The
maximum length of the signature is 512 characters.
Function Defaults Change the function default settings in [ Common/Job Default Settings ] page.